A Windows Based PC with full administrative Rights be able to run programs in administrative mode To make sure the PC is connected to the network either wirelessly via Ethernet. A Wireless Network - such as a broadband router. An active Internet connection on your PC. This sounds a lot more complicated than it really is. Bob DiVincenzo Reply to:Bluehog.Wireless printing can be difficult to get your head around as it requires your MaxiSys to communicate with your PC through a network. Maybe 64GB was too high for it to read? Hope this helps. Since the updates only came to about 2 or 3GB, I went ahead and put the updates on the card that came with the scanner and now when I plug it into my car, it works.
So I did my update on a card that was 64GB. I hope this help, the fact is that the PC Windows 10 have problems recognizing the Microcard inside the Maxilink as a Drive, and there lies the problem, but if you take it outupdate it with an adapter, put it back in the MaxiLink, run your test, and then connect to the PC, run the Playback button, run PC Link, everything works fine. I put it back in the MaxiLink and connected the unit to my Audi, and I run every test I could with the unit.
If you remove the card and put it into an Adapter for regular SD card and provided you have a port for it, is recognized immediately as a Drive and the Maxi PC Suite recognize it and you can download your updates.
So their response was to read you the manual and not deal with has become a known issue connecting the ML to a PC? Here was their response: Hello Sir, Thank you for email. Maxilink ML unable to connect to my computer.īluehog I have tried 3 different USB ports directly on the desktop computer not thru a hub or display. For more detailed steps, please refer to of user manual above. The your device can be recognized the app, and you will be ready for printing. If you were trying to print via Autel Printer, you should connect the device to computer with USB cable, run Autel Printer software on computer, select Playback on the main screen of the device. Or you can take out the TF card from the scan tool and load it to computer with a card reader. Please make sure you fully understand all instructions on updating and printing for ML Left Scroll button and connect the device to computer with USB cable. Seems I missed some instructions that I originally followed My Bad! This did not repair the problem Hope someone from Autel can help Thought I would give an update I contacted Autel support. I then reinstalled the Suite which also reinstalled the PC Link print program. I originally downloaded the software and did a full vehicle update This removed the suite software as well as the PC Link print software.